Fitted up the Holley Blue pump (red regulator will be used for 3-3.5psi pressure)...-8 AN lines and fittings used for main fuel line.
Viewed: 473 times.
|
Fuel line will exit tank via a welded in -8 bung, through -8 line to filter, then to a 180 degree U-bend fitting into pump. Nuts welded to 'firewall' to mount pump (rubber spacer to be used to minimise vibration/noise).
Viewed: 375 times.
|
I decided to have a -4 AN fitting for the breather line so had one tig welded in place. Although tank has been powdercoated and clearcoated already, the burnt off paint will be patched and matched eventually.
Viewed: 419 times.
|
Also had a -8 fitting welded in to allow braided line to be used from the tank. Again paint will be repaired in time.
Viewed: 428 times.
|
Also fitted the gas charged bonnet struts - pretty easy process again (bought them from aircooled.net). Will hopefully bolt the bonnet up tomorrow to check fit etc.
Viewed: 466 times.
|
